INCH-POUND
A-A-52212
October 23, 1996
SUPERSEDING MIL-G-21196B
20 February 1968 (see 6.5)
COMMERCIAL ITEM DESCRIPTION GAGE, CYLINDER
The General Services Administration has authorized the use of this commercial item description for all federal agencies.
1. SCOPE
1.1 Scope. This commercial item description (CID) covers one type of cylinder gage.
1.2 Intended use. The gage is used to measure engine cylinder bores for straightness, out of roundness, and taper diameters.
2. SALIENT CHARACTERISTICS
2.1 Design and construction. The cylinder gage shall be similar to figure 1, and shall have a range of 2 1/2 to 9 inches. The cylinder gage shall have a dial indicator attached to a mounting
block. The mounting block shall be attached to a slide base to permit alignment of the gage.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: U.S. Army Natick Research, Development and Engineering Center, Natick, MA 01760-5018 by using the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A FSC 5210
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business